Jetting for IAME kart engines 4+
ISEnet
Designet til iPad
-
- 49,00 kr
Skærmbilleder
Beskrivelse
This app provides, for the current weather conditions and a given engine configuration (engine model, gas, etc.), a jetting and exhaust length recommendation for IAME Parilla X30 Senior or Junior (Tillotson & Tryton carbs), X30 Super 175cc & Leopard engines.
In order to get the weather values, the application can use the GPS to obtain the position and altitude, and the network connection to get the temperature, pressure and humidity from the nearest weather station. Nevertheless, the application can run without GPS and internet connection, in this case, the user has to give the weather data.
The application is made up of four tabs that are described next.
- Results: In this tab, a recommended jetting and exhaust length setup are shown. These data are calculated depending on the weather conditions and the engine and track configuration given in the following tabs. The following values are given: high needle, low needle, pop-off pressure and exhaust length. Besides this information, the air density and density altitude are shown too. In addition, this tab lets do a fine tunning adjustment for the high and low needles to adapt to the concrete engine.
- Weather: In the second tab, called Weather, you can set the values for current temperature, pressure, altitude and humidity. The values of this screen can be manually set or can be loaded by the application reading the data from the nearest weather station (from the GPS tab).
- Engine: You must set in this screen the information about the engine, that is, the engine type (Leopard, X30 Senior, X30 Junior X30 Super), carburetor, exhaust restrictions (for Junior engines), the oil mix ratio and the type of the circuit (short or long tracks). Depending of the track type, the jetting setups will be adapted.
- GPS: This tab allows to use the GPS to get the current position and altitude, and connect to an external service to get the weather conditions of the nearest weather station (temperature, pressure and humidity).
The application works with different measure units: inHg, mb, mmHg, hPa, atm for pressure, ºC and ºF for temperature.
Nyheder
Version 1.7
Minor adjustment in the calculation model of junior engines after testing on the dynamometer.
App-anonymitet
Udvikleren, ISEnet, har angivet, at fremgangsmåder vedrørende app-anonymitet muligvis inkluderer håndtering af data som beskrevet nedenfor. Du kan få flere oplysninger her: udviklerens anonymitetspolitik.
Data, der ikke er tilknyttet dig
Følgende data vil muligvis blive indsamlet, men de er ikke tilknyttet din identitet:
- Id'er
- Brugsdata
- Diagnostik
Fremgangsmåder vedrørende anonymitet kan variere, f.eks. baseret på de funktioner, du bruger, eller din alder. Læs mere
Oplysninger
- Leverandør
-
Ingenieria del Software ISEnet S.L. har identificeret sig selv som en forhandler af denne app og har bekræftet, at produktet eller tjenesten er i overensstemmelse med EU-lovgivning.
- DUNS-nummer
- 460049962
- Adresse
- Calle De Las Moreras, 25 - A 1 B 28300 Aranjuez Madrid España
- Telefonnummer
- +34 600430897
- mobile@isenet.es
- Størrelse
- 2,6 MB
- Kategori
- Sport
- Kompatibilitet
-
- iPhone
- Kræver iOS 12.0 eller en nyere version.
- iPad
- Kræver iPadOS 12.0 eller en nyere version.
- iPod touch
- Kræver iOS 12.0 eller en nyere version.
- Mac
- Kræver macOS 11.0 eller en nyere version og en Mac med Apple M1-chip eller en nyere version.
- Apple Vision
- Kræver visionOS 1.0 eller en nyere version.
- Sprog
-
Dansk, Arabisk, Engelsk, Finsk, Forenklet kinesisk, Fransk, Græsk, Hebraisk, Hollandsk, Indonesisk, Italiensk, Japansk, Koreansk, Malaysisk, Norsk - bokmål, Polsk, Portugisisk, Rumænsk, Slovakisk, Spansk, Svensk, Thailandsk, Tjekkisk, Traditionelt kinesisk, Tyrkisk, Tysk, Ukrainsk, Ungarsk, Vietnamesisk
- Alder
- 4+
- Copyright
- © 2023 Ingeniería del Software ISEnet S.L.
- Pris
- 49,00 kr
Understøtter
-
Familiedeling
Op til seks familiemedlemmer kan bruge denne app, når Familiedeling er aktiveret.