Jetting for IAME kart engines 4+

ISEnet

Σχεδιάστηκε για iPad

    • 6,99 €

Στιγμιότυπα

Περιγραφή

This app provides, for the current weather conditions and a given engine configuration (engine model, gas, etc.), a jetting and exhaust length recommendation for IAME Parilla X30 Senior or Junior (Tillotson & Tryton carbs), X30 Super 175cc & Leopard engines.

In order to get the weather values, the application can use the GPS to obtain the position and altitude, and the network connection to get the temperature, pressure and humidity from the nearest weather station. Nevertheless, the application can run without GPS and internet connection, in this case, the user has to give the weather data.

The application is made up of four tabs that are described next.

- Results: In this tab, a recommended jetting and exhaust length setup are shown. These data are calculated depending on the weather conditions and the engine and track configuration given in the following tabs. The following values are given: high needle, low needle, pop-off pressure and exhaust length. Besides this information, the air density and density altitude are shown too. In addition, this tab lets do a fine tunning adjustment for the high and low needles to adapt to the concrete engine.

- Weather: In the second tab, called Weather, you can set the values for current temperature, pressure, altitude and humidity. The values of this screen can be manually set or can be loaded by the application reading the data from the nearest weather station (from the GPS tab).

- Engine: You must set in this screen the information about the engine, that is, the engine type (Leopard, X30 Senior, X30 Junior X30 Super), carburetor, exhaust restrictions (for Junior engines), the oil mix ratio and the type of the circuit (short or long tracks). Depending of the track type, the jetting setups will be adapted.

- GPS: This tab allows to use the GPS to get the current position and altitude, and connect to an external service to get the weather conditions of the nearest weather station (temperature, pressure and humidity).

The application works with different measure units: inHg, mb, mmHg, hPa, atm for pressure, ºC and ºF for temperature.

Τι νέο υπάρχει

Έκδοση 1.7

Minor adjustment in the calculation model of junior engines after testing on the dynamometer.

Απόρρητο εφαρμογής

Ο δημιουργός «ISEnet» υπέδειξε ότι οι πρακτικές απορρήτου της εφαρμογής ενδέχεται να περιλαμβάνουν τον χειρισμό δεδομένων όπως περιγράφεται παρακάτω.Για περισσότερες πληροφορίες, δείτε την πολιτική απορρήτου δημιουργού.

Δεδομένα που δεν συνδέονται με εσάς

Τα ακόλουθα δεδομένα μπορεί να συλλεχθούν αλλά δεν συνδέονται με την ταυτότητά σας:

  • Αναγνωρι­στικά
  • Δεδομένα χρήσης
  • Διαγνωστικά

Οι πρακτικές απορρήτου μπορεί να διαφέρουν, για παράδειγμα, βάσει των δυνατοτήτων που χρησιμοποιείτε ή της ηλικίας σας. Μάθετε περισσότερα

Υποστηρίζει

  • Οικογενειακή κοινή χρήση

    Μέχρι έξι μέλη της οικογένειας μπορούν να χρησιμοποιούν αυτήν την εφαρμογή όταν η Οικογενειακή κοινή χρήση είναι ενεργοποιημένη.

Περισσότερα από αυτόν τον δημιουργό

Kart Chassis Setup Premium
Αθλητικά
Jetting Max Kart for Rotax Max
Αθλητικά
Jetting TM Kart for KZ / ICC
Αθλητικά
Jetting for Rotax Max EVO Kart
Αθλητικά
Jetting for KTM 2T Dirt Bikes
Αθλητικά
Jetting for Honda CR 2T
Αθλητικά

Ίσως σας αρέσει επίσης

Jetting for IAME X30 Karting
Αθλητικά
Jetting IAME OK OK-Junior Kart
Αθλητικά
Jetting IAME SWIFT & GAZELLE
Αθλητικά
Jetting IAME KA100 & KFS FFSA
Αθλητικά
Jetting IAME KZ1 / KZ2 Kart
Αθλητικά
Kart Chassis Setup PRO
Αθλητικά