COMPUTHERM E Series 4+

Kis trukkozessel megy/Working with some trick

Nem kapcsolodott a termosztathoz. Leszeded a Beok home alkalmazast, az hozza tud csatlakozni. Utana ha elinditod ezt, mar latni fogja.
If you have connection issue:
First download Beok home app from here. This can connect to the thermostat. Then run the Computherm app, and you can see the termostat and use the app correctly.

Cannot connect to the thermostat

I am very desperate about configuring the thermostat.

I have a Computherm E280 and try to configure it to my network.

I followed all alternative instructions I found on the internet or on the app “Possible causes of wifi connection or failure”

I reset the thermostat by holding long ⏰ then pressing the power button:
- setting FAC to 32 (didn’t work)
- setting FAC to 10 (didn’t work)
- setting FAC to 00, then turning off and pressing 🔼 for 10 seconds (didn’t work)

The small wifi icon is flashing as it should be and I’m on a 2.4 GHz wifi network, but during the connection part a failure is raised. I also turned the electricity off and on but still no results.

Sorry for the bad feedback, maybe this app is good but I didn’t get there to experience it.

If there is any suggestions I would appreciate it.

Dark theme issues

While dark theme is set in IOS, the app still does not work properly. Name of equipment in the list, wifi, and even the timer settings are not visible.
Thus the app is useless and does not fulfill it’s original goal, to be able to manage the heating system remotely.

Don’t know how many negative feedbacks are still needed to get this working. Many other apps support dark mode so I guess it’s technically possible. Someone from the developer company shall pick this up after 1.5 years…

Fejlesztői visszajelzés ,

We are sorry for the problem and looking for the solution at the moment.