ADs consent management for EU and UK within free version.

maintenance release

* Fixed iOS17 Bug where inApp purchase must be restored each time the App was killed by OS. * BMS Settings Screen: Discharge Capacity field was expecting always dot as decimal separator. now based on locale comma separator is accepted.

BugFix where cell voltages were not displayed for some BMS FW

- Fixed bug where the HW PIN is not stored locally / must be entered each time to enter config area or switch MOSFET Ports On/Off - Removed warning if BMS has no HW PIN set

* macOS version available (ARM Machines) * added support for latest JBD BMS with FW > 25 (like JBD-AP21S001) * only for new JBD BMS (buttons are visible if connected to supported BMS): * Button to start balancer manually * Button to reset alarms * fixed Input/Output port on/off functionality (new commands)

BMS Settings Screen: added fields for preciser SOC setting (10%, 30%, 50%, 70%, 90%, 100%). NOTE: works only on BMS firmware above version 21 and some 20.

* BMS Screen: now you can set custom name for temp sensors * BMS Settings Screen: latest FW version does not support PIN anymore. You will be not asked anymore to enter PIN on this FW version.

BMS Settings Screen: extended total battery voltage to 6 digit (36s batteries) to allow total voltage over 100V.

BMS Settings Screen: extended total battery voltage to 6 digit (36s batteries) to allow total voltage over 100V.

- small UI improvements

maintenance release

HotFix for Settings PIN verification bug

- Protect your battery / BMS board settings with hardware PIN (only for Firmware > v20). - Added separate toggles to switch MOSFET on/off

now you can change bluetooth advertised name of your BMS (settings section) NOTE: works only with newer BT dongles

Fixed software PIN1 length.

* BMS Settings Screen: from BMS Firmware version 20 you can protect your settings on BMS side. with this version we added option to unlock BMS if settings area is protected with hardware pin. NOTE: Setting hardware pin and changing bluetooth dongle name is under development and will come with next release! * BMS Screen: show firmware version

This version fixes app crash for certain users.

- Toggle to pause devices scan (main screen) - Improved BMS configuration readout (time reduction)

Fixed invisible NTC toggles (config section) on older devices (iOS 12 and older)

- fixed DSGOV (Discharge Overvoltage) value write to BMS in settings section

increased maximal number of cells to 32 (config section)

* added support for BMS with HC01 bluetooth dongle * Notification screen: fixed decimal truncation with locales using comma

Fixed "waiting for data" connection problem for some BMS

connection optimisation for new BMS