Trimble Earthworks GO‪!‬ 4+

ATTENTION! This is the original Trimble Earthworks GO! app, not to be confused with Trimble Earthworks GO! 2.0

Trimble Earthworks GO! is a machine control platform built with the small contractor in mind. Earthworks GO! automates your compact machine grading attachment so you can complete your projects faster and more accurately. Download the app interface to use with your Earthworks GO! grade control system.
Supercharge your grading projects with a system that just works, right out of the box. Earthworks GO! offers fully automatic control of your compact grading attachments with minimal setup required. With its user-friendly interface, integrated setup tutorials, and high-precision sensing technology, Earthworks GO! was built with a single purpose in mind: to save contractors time and money.

Get the newest machine control platform from the company that invented the technology. This is just one more way Trimble is transforming the way the world works.

Note: Trimble Earthworks GO! requires Trimble machine control hardware. Please contact your local SITECH dealer for more information: https://heavyindustry.trimble.com/en/where-to-buy

Three tiers of the Trimble Earthworks GO! system are available: Slope guidance only, Slope and Depth Offset (Single Laser Receiver), and Slope plus Dual Depth Offsets (Dual Laser Receivers). Your Sitech Dealer can help you choose the system to best address your grading needs.

Known Issues:
- On some devices the joystick animations may be slow to start. Tapping “Next” or “Back” should refresh the animation and resolve the issue.
- If a Bobcat attachment is powered up with the LR410s connected but without the GO! Box connected, the laser receivers may not show up in the Earthworks GO! application. Cycling power to the system or disconnecting/reconnecting the LR410s will resolve this.
- After upgrading a GO! Box from V1.3.0 to V1.4.1 using an iOS device, the user may be prompted to re-connect to the GO! Box twice.
- A “Multiple Lasers Detected” error may be seen when working near reflective objects (glass, machine cabs, metal, etc.). The laser can reflect off these surfaces causing a secondary strike at the receiver. Make every attempt to limit these reflective surfaces. Raising the receivers out of the laser plane may clear this error as well. If the problem persists, contact your local SITECH dealer for the latest LR410 firmware.
- When connecting an iOS device to the GO! Box, the “Go to Wi-Fi Settings” link may take you to the general device settings. The user will need to enter the Wi-Fi settings from there.
- When changing the combination of a basic attachment and a machine with GO! Switches, the GO! Switch button mapping may be incorrect. If you find this, closing/reopening the app or deselecting/reselecting the attachment will resolve the issue.