beurer HealthManager 4+

I am using Healthmanager for few years. It was ok, until update in 2018 when new user interface was introduced. Since then I am lost, graphics show flat lines (they chose wrong range, small changes in values are not visible), change of the period in graphics was deletad (or is hidden and I can not find it). In general new interface is much less informative than the old one. I don’t like it.

I use the app connecting via Bluetooth with two devices: blood pressure meter BM85 and bathroom scales BF600.
With the first one the experience was so bad at the beginning that only one person data synchronisation is performed now, and the experience became much better - the app doesn't mix the users or accounts, I just need to remember and remove not mine data from the app periodically.
With the scales thou, the experience is a pure ordeal. Two people use the scales but four profiles were created by the app on the scales, so we have to remember which number on the scales we are; there is no way to remove the superfluous profiles. Sometimes the scales makes full measurement, sometimes not; sometimes it recognises us (10 kg difference), sometimes not; sometimes the device and the app are connected although the scales screen is off (good), sometimes they loose connection for no apparent reason in the middle of scrolling data in device section of the app. And finally the app regularly forgets the device, doesn't recognise it and we have to manually add PINs to sync our profiles and data. Recommendation: give a try to another bathroom scales, the blood pressure meter is OK for single person use.

Hi,

I started using HealthManager iPhone app yesterday. I'm using few of the available accessories (PO 60, BC85, BF800).

I have some observations:
HealthManager is not writing Muscle Mass parameter to Apple Health App although it's available from BF800
My pulseoximeter PO60 is not deleting it’s data after synchronisation. When I remove some of the result by hand, they are put back again after synchronisation. This also makes it impossible to use it by more then one person - others data would be put in my app
PO60 exports the whole measurement as a one record - I was doing a test for 10 minutes and got only one record with average data. My heart rate changes a lot and it’s not possible to show it using avg measurement
Initial date/time when exporting data from PO60 was year 2001. It should synchronise date before exporting data
would be good to scroll my daily chart. If there’s a lot of measurements I’m not able to see them on the chart. Also time intervals on the chart are not proportional