Jetting for IAME kart engines 4+
ISEnet
Designad för iPad
-
- 79,00 kr
Skärmavbilder
Beskrivning
This app provides, for the current weather conditions and a given engine configuration (engine model, gas, etc.), a jetting and exhaust length recommendation for IAME Parilla X30 Senior or Junior (Tillotson & Tryton carbs), X30 Super 175cc & Leopard engines.
In order to get the weather values, the application can use the GPS to obtain the position and altitude, and the network connection to get the temperature, pressure and humidity from the nearest weather station. Nevertheless, the application can run without GPS and internet connection, in this case, the user has to give the weather data.
The application is made up of four tabs that are described next.
- Results: In this tab, a recommended jetting and exhaust length setup are shown. These data are calculated depending on the weather conditions and the engine and track configuration given in the following tabs. The following values are given: high needle, low needle, pop-off pressure and exhaust length. Besides this information, the air density and density altitude are shown too. In addition, this tab lets do a fine tunning adjustment for the high and low needles to adapt to the concrete engine.
- Weather: In the second tab, called Weather, you can set the values for current temperature, pressure, altitude and humidity. The values of this screen can be manually set or can be loaded by the application reading the data from the nearest weather station (from the GPS tab).
- Engine: You must set in this screen the information about the engine, that is, the engine type (Leopard, X30 Senior, X30 Junior X30 Super), carburetor, exhaust restrictions (for Junior engines), the oil mix ratio and the type of the circuit (short or long tracks). Depending of the track type, the jetting setups will be adapted.
- GPS: This tab allows to use the GPS to get the current position and altitude, and connect to an external service to get the weather conditions of the nearest weather station (temperature, pressure and humidity).
The application works with different measure units: inHg, mb, mmHg, hPa, atm for pressure, ºC and ºF for temperature.
Nyheter
Version 1.7
Minor adjustment in the calculation model of junior engines after testing on the dynamometer.
Appintegritet
Utvecklaren ISEnet har angett att appens integritetsrutiner kan inkludera hantering av data enligt beskrivningen nedan. Det finns mer information i utvecklarens integritetspolicy.
Data som inte kopplas till dig
Följande data kan samlas in men den kopplas inte till din identitet:
- Identifierare
- Användningsdata
- Diagnostik
Sekretessriktlinjer kan variera, till exempel utifrån de funktioner du använder eller din ålder. Läs mer
Information
- Leverantör
-
Ingenieria del Software ISEnet S.L. har identifierat sig som appens näringsidkare och har bekräftat att produkten eller tjänsten överensstämmer med gällande EU-lagar.
- D-U-N-S-nummer
- 460049962
- Adress
- Calle De Las Moreras, 25 - A 1 B 28300 Aranjuez Madrid España
- Telefonnummer
- +34 600430897
- E-post
- mobile@isenet.es
- Storlek
- 2,6 MB
- Kategori
- Sport
- Kompatibilitet
-
- iPhone
- Kräver iOS 12.0 eller senare.
- iPad
- Kräver iPadOS 12.0 eller senare.
- iPod touch
- Kräver iOS 12.0 eller senare.
- Mac
- Kräver macOS 11.0 eller senare och en Mac med Apple M1‑chip eller senare.
- Apple Vision
- Kräver visionOS 1.0 eller senare.
- Språk
-
svenska, arabiska, danska, engelska, finska, franska, förenklad kinesiska, grekiska, hebreiska, indonesiska, italienska, japanska, koreanska, malajiska, nederländska, norska bokmål, polska, portugisiska, rumänska, slovakiska, spanska, thailändska, tjeckiska, traditionell kinesiska, turkiska, tyska, ukrainska, ungerska, vietnamesiska
- Ålder
- 4+
- Copyright
- © 2023 Ingeniería del Software ISEnet S.L.
- Pris
- 79,00 kr
Support
-
Familjedelning
Upp till sex familjemedlemmar kan använda den här appen när Familjedelning är aktiverad.