ChargePro 2.0 ١٧+

Name: ChargePro 2.0
Rating: 2.1 (10 reviews)
Author: HNE

HNE

مصمم لـ iPad

- ٢٫١ • ١٠ من التقييمات

- مجانًا

الوصف

ChargePro 2.0 is designed for remote operation & monitoring on solar charge controller in any solar DC charge systems.

This APP is used as a remote display and operation panel for the relevant solar charge controller (an external or inbuilt BT module is required for usage). By operation on this APP, you can check the status of PV, battery, DC load for the solar DC charge system with charge controller.

We have 3 main pages of operations in this APP. The first page is for displaying the status of the system, the 2nd page is for displaying the historical data, the last page is for displaying the parameters for settings, and we also have 2 slide menus for displaying the device information and BT connection. Except for showing the present system information, we also can set the parameters for the charge controllers in the parameter setting pages, like for battery type, battery charge & discharge voltages, load mode settings and etc.

For more information, please contact the solar charge controller providers.

١١ يوليو ٢٠٢٤

الإصدار 1.0.12

Some known problems are optimized

٢٫١ من ٥

١٠ من التقييمات

Issues with the app

The historical data says it’s been running for thousands of days but it has only been weeks. The charge percentage is always off to some degree. I can see if the two mppt’s are in parallel in the app.

It needs significant improvements and in its current version is useless

My app says it’s connected to the solar controller, but there is no input or output, Even though the system is connected to power. I've tried it with solar, shore, and vehicle power with the same results. It shows zeros in all categories except for the battery, which shows 100% regardless of the battery level. It also doesn't show the device model or version. So, in other words, the app is useless.

The “state of charge” Is horrible.

I love the charger controller so far but the app is severely lacking.
Right now my actual voltage in a 48 volt lithium battery bank is 50.9 volts which is around 16% charged.
My app is showing my state of charge at 75%!!!!

I understand if it was a little off but this isn’t even close!

Why can’t you allow the user to set the parameters for the state of charge meter?

أوضح المطور HNE، أن ممارسات خصوصية التطبيق قد تتضمن معالجة البيانات على النحو الموضح أدناه. لمزيد من المعلومات، انظر %سياسة خصوصية المطور(ة) سياسة خصوصية المطور.