GWCAMVIEW 4+

I have been using this app for awhile and it is very fast to render the video unlike several other surveillance camera apps that I use. I would really like the PTZ to be a little less confusing and would strongly like the PTZ camera to have a “home” position on power up. Every time I take a power hit, it is pointing down so the motion alert feature is rendered useless. All in all, this is a good app for remotely watching the live view. Still a little difficult to use it for effective video playback.

This is a pretty decent remote viewer app for my GW camera system. But the major improvement I’d like to see is the ability to fine tune notifications, so I can a notification for motion detection, but turn off notifications for loss of signal which is constantly happening when using WiFi cameras. As it is, if I leave notifications turned on, I get dozens of them for loss of signal, instead of the two or three I actually want for motion detected. So I just turn notifications off, which isn’t helpful.

I’ve been using this app for quite a few years, lately it started giving a lot of problems. When I need to see my cameras I get blank screen, when I go to device management, I get error connecting.I have to remove device, set it up with the IP address. It works one or two times, then error again, then I delete the device, and set it up again with the barcode. And that goes over and over and over again every day. No I have to device is set up, one with IP address, the other one set up from the barcode. Sometimes one or the other kicks in. I understand that this is a very messy set up but this is the only way this thing works