The LabNation SmartScope app - A full-feature oscilloscope in your pocket

Turn your iDevice into an oscilloscope using this app. Combined with the LabNation smartscope and a wifi scope access point, you can wirelessly control and view your smartscope.

Supports the dummy scope mode and network scope over wifi

Download the SmartScope App to obtain the server software from our website

What’s New

Version 0.15

[All] Store/Load Presets (configurations)
[All] Active decoders (and their settings) now saved between sessions
[All] Wave colors are now also stored/loaded to/from file
[All] Partial save/load: you can now select which settings to store/load
[All] Full wifi-bridge support
[All] Now possible to configure wifi bridge to connect over existing wifi (allowing internet access while connected to wifi bridge)
[All] Added wifi menu, showing active wifi APs and their signal strength
[All] Wifi icon shown instead of USB icon when connected to scope over wifi
[All] Various improvements/fixes
[All] Bugfix: where DigitalChannels didn't show data for slow and rolling acquisitions
[All] Bugfix: rolling mode now always responds immediately
[All] Upon insertion of SmartScope, scope is automatically started. Afterwards, DummyScope is not started by default
[All] MeasurementBox parked at right side now shows value for all measurements
[All] Keyboad now also support upper/lower case
[All] Crashfix when storing rolling data to matlab file
[All] Decoder added: Manchester encoding
[iOS] reduced mim iOS version to 9.3 (so iPad2 is still supported)

Ratings and Reviews

5.0 out of 5
1 Rating

1 Rating


Jasper van Bourgognie
133.6 MB

Requires iOS 9.3 or later. Compatible with iPhone, iPad, and iPod touch.

Age Rating
Rated 4+
© LabNation BVBA


  • Family Sharing

    With Family Sharing set up, up to six family members can use this app.

You May Also Like