petMAP Remote Display 12+

The petMAP Remote Display Application allows users to view measurement results and waveforms displayed on the petMAP’s display in real-time on IOS devices. When downloaded and installed on an IOS device ( iPhone or iPad), petMAP Remote Display connects to the petMAP using Bluetooth LE(Low Energy) technology.

To use the Application, simply power on the petMAP device and open petMAP Remote Display. The Application will automatically begin searching for a petMAP device and connect to it. Allow thirty seconds to a minute for the Application to connect to the petMAP (it may take a little longer depending upon how many wireless devices are within the vicinity).

Once connected, the petMAP’s Bluetooth icon will change to blue and the petMAP Remote Display Application will automatically mirror the display of the petMAP in real-time. Touching the top bar of the screen will allow the user to disconnect from the petMAP device if desired.

Note: If the petMAP is not Found by the Application, re-start the petMAP by turning it OFF, waiting five seconds, and turning it back ON, then select Retry.

Note: petMAP Remote Display may prompt to enable your device’s Bluetooth function if it is not enabled. Bluetooth must be enabled to use the Application.