- Lumio Air: Fixed a crash that could occur following a firmware update. - Lumio Air: Fixed GPS signal reading (the status was inverted) and ensured an "invalid data" message is displayed instead of a 1970 date when the module has not received a signal. - Lumio Air: Fixed an issue where a disconnected module remained listed among recognized modules while the scanner was paused. - Navigation: Significant improvement in loading performance for sets and luminaires. - Navigation: Identified an issue where sets and luminaires may temporarily disappear after certain changes (such as modifying a set). This occurs because, in some of these cases, the synchronization process is comprehensive and resource-intensive; however, no data is lost. This issue will be fixed in an upcoming release.

- Synchronization: Fixed an issue where program lists could fail completely due to invalid or incomplete data. - Synchronization: Limited the number of simultaneous requests to improve data retrieval reliability. - Lumio Air: Fixed a crash that could occur after a firmware update. - Lumio Air: Fixed the live test function when a module controls two luminaires (the module was incorrectly treated as a dynamic white unit). - Lumio: Added an error message for cases where no DALI driver is detected on the Light screens or in an empty module slot. - Lamp: Fixed the display and pre-filling of ULR values ​​(two-decimal precision and conversion from the purchased lamp).

- Programming: Profile and program templates provided by Rohl now appear at the top of the list, identified by the Rohl logo and their name in green. They can be viewed and copied but are never included in profile or program selection lists. - Profile: A duplication button has been added to night profile records; clicking it opens a creation form pre-filled with the original profile's specifications. - Connection: Improved certain processes related to module synchronization. - Lumio Air: Fixed a one-hour offset (daylight saving time) that occurred when manually setting the time to a date falling within the winter time period. - Program: Fixed an issue where the nominal power could not be modified in connected mode. - Program: Fixed an issue where the program did not appear in navigation mode. - Program: Improved touch responsiveness on the power bar.

- Synchronization: Fixed numerous issues preventing certain data from correctly uploading to the back-office (cleaned up data fields sent for all elements: streetlamps, lamps, drivers, profiles, documents, etc.). - Synchronization: Disconnecting an electrical cabinet circuit now correctly updates the back-office. - Lumio: Fixed an issue that prevented connection to modules when certain non-essential data was delayed—specifically when the goal was a firmware update. - Lumio: Fixed an issue reading profile references (unused ballast or corrupted data) that could block programming synchronization. - Lumio: Fixed an issue that allowed connections to modules for which access was not authorized. - Streetlamp: Fixed a duplication issue where associations and modifications made after saving were applied to the original streetlamp instead of the new one, if the scanner was opened from the redirection screen shown at the end of the process. - Program: Nominal power information no longer appears in the program view.

Fixes: - Synchronization: Fixed an issue where synchronization could get stuck after a data retrieval failure. - Synchronization: Fixed several issues preventing certain data from correctly uploading to the back-office. - Profile: Fixed an issue where applying a profile from the catalog did not update the editor (specifically when switching to a night profile). - Location selection: Fixed an issue where the selection of a scheduled GIS location was not being registered. - Association: Fixed an issue where a specific ballast address could not be selected in the selector. - Association: Added a message displayed when no lamp is available for association.