NEW: The app now reconnects by itself. Previously, turning the ignition off at a stop dropped the Bluetooth link and the app never got it back — Live Monitoring reported "connection lost" while the sensor battery levels still looked fine, and the only fix was to force-quit and reopen the app. That is gone. - Live Monitoring stays on screen when the link drops. The gauges grey out, a slim "Reconnecting…" banner appears, and live values resume by themselves once the ignition is back on - Reconnect attempts start almost immediately and then ease off, so a quick fuel stop recovers in a second or two without draining your battery when the bike is parked for the night - If the controller restarted while you were away, the app notices and re-reads your settings automatically - Sensor battery levels and settings now show "—" while the connection is down, instead of continuing to display the last value as though it were current - A single failed reading no longer reports both sensors as 0% or shows "setup required" on a properly configured bike Also in this update, for anyone coming from 1.3.0: - Customizable pressure alerts — tap the settings button in Live Monitoring to set your own low and high pressure limit for each tire, with sound and vibration the moment a tire crosses it - Fixed: tire temperature now displays correctly (for example 23.6°C instead of 2360°C) - Calibration is shown as an easy-to-read percentage everywhere, with a clearer "Match my gauge" flow - Sensors no longer briefly drop from Live Monitoring after a calibration change - Live gauge values are centered and never crowd the ring - Pressure entry fields accept both "," and "." as the decimal separator (European keypads) Note: the alert sound follows your ring/silent switch; vibration always fires. Live Monitoring requires controller firmware 1.10.0 or newer. Automatic reconnect works with any firmware; the added liveness check requires firmware 1.11.0 or newer, which your controller will offer as an update.

NEW: Customizable pressure alerts — tap the settings button in Live Monitoring to set your own low and high pressure limit for each tire, with sound and vibration the moment a tire crosses it (repeating while critical). Also in this update: - Fixed: tire temperature now displays correctly (for example 23.6°C instead of 2360°C) - Calibration is now shown as an easy-to-read percentage everywhere, with a clearer "Match my gauge" flow that reminds you to apply and confirms before you leave with unsaved readings - Sensors no longer briefly drop from Live Monitoring after a calibration change - Live gauge values are centered and never crowd the ring - Pressure entry fields accept both "," and "." as the decimal separator (European keypads) Note: the alert sound follows your ring/silent switch; vibration always fires. Live Monitoring requires controller firmware 1.10.0 or newer.

- Color-coded alerts: yellow when pressure runs low or high, flashing red on severe pressure loss or overpressure - Night-friendly: per-screen light/dark override, and the display stays awake while monitoring - Show pressures in PSI or bar, temperatures in °C or °F - Improved sensor trim interface — match readings to your gauge more easily Live Monitoring requires controller firmware 1.10.0 or newer — update from the device screen.

Version 1.2.2 • Each sensor now has its own settings screen for address, calibration, battery, and recent changes. • Settings save automatically — no more manual save or reset. • Recent Changes lets you review and undo edits to a sensor. • Clearer first-run guidance when a sensor needs setup or isn't reporting yet. • Friendlier device list: controller name, short ID, and signal strength instead of raw MACs. • Pull down on the device screen to refresh sensor readings. • Various stability and performance improvements.