Bugfix and updates - Address Reboot in IDLE mode issue - Add support for TeleMegaV5, and TeleMegaV6 telemetry packets

Fixes specific to various Flight Computers - Fixes for TeleMetrum V1 (earlier boards) and repair interp for max Height calcs - Visual Adjustments for TeleMini (remove values not applicable to TeleMini) - Fixes to TeleGPS V1 & V2 displayed voltages General Fixes - Improve walk to rocket experience (more-accurate values reported more frequently) - Replace algorithm determining need for flight meta-data rebuild (stop the rebuild many times nonsense) - Speech subsystem renovated to reduce delay from interpret value to speak value - Repair reporting of elevation (incorrect spoken text) - Repair reporting of maxHeight (was reporting before max was actually achieved) - Repair GPS Ready reporting when GPS-lock is lost/recovered

- Adds support for TeleMegaV4 Flight Computer - New TeleGPS algorithmic flight-state detection and tab switching - Cleaned up Voice flight following for TeleMini - Fixes to voltages displayed for TeleMetrum v1.x, TeleMini v1.0 and TeleNano flight computers - New "Callsign Prefix" in Setup to allow gathering of own devices at top of Select Tracker Picker - New "Show Launch Sites" switch in Setup which places circles for all known sites in the map in Map Tab - Tap on a Launch site circle to see name and link to website for Launch Site - Selection of a past flight now displays max height, max speed, etc. correctly in various tabs - Fixes to IDLE mode operation - Updates to user interface adopting some changes from AltosDroid app. - Address readability problems when phone in darkmode - Clean up User Interface on smaller screens - Fixed a number of crashes

Repaired crash when selecting recorded flight from Select Tracker dialog.

This release addresses issues found during flight testing by our user community (thanks to those of you reporting what you are seeing our app is getting better for all of us!) - Add recovery voice support to map view - Repair units and scaling for distances and heights - Clean up voice announcements (units and scaling) - Added missing feature of keeping list of trackers heard and ability to reconnect to them quickly - Launch pad and landing locations are now shown in map view when appropriate - This requires onetime rebuild of metadata for your recorded flights when this verison is first run - Added filter so only selected tracker data is presented when more than one tracker are on same channel

Fixes in this release: (Please install this update) - Repaired condition where seeing a new TeleBT v4 device for first time may fail to communicate with BT device. - Adapts to the new location for the launch-sites data and adds an alert detailing when the list of launch sites can't be loaded. New in this release: - Added PAD icon in map view - seen when walking to landed rocket.

New in this release: - Full IDLE mode support! (for ground preparation and testing of your rocket.) - Fixes to distance calculations and scaling.

V1.4 brings fixes to adding complete support for the rest of the Altus Metrum flight computers. - TeleMetrum support has been adjusted to display telemetry at full rate - Additional adjustments have been made adding TeleMini full support rounding our our set. - Minor adjustments have been made to improve the receipt of telemetry packets from the TeleBT. This completes the certification and adjustment of this applications support for the TeleMega, TeleMetrum, TeleMini and TeleGPS flight computers.

More corrections to behavior and display. For details see the "Releases" page at our web site.

Corrections to behavior and display. For details see the "Releases" page at our web site.

Minor updates (prevent access to IDLE Mode subsystem until it's ready for use!)