• New: Measure — a tap delay checker. Tap twice and read the interval in milliseconds, frames, timecode, BPM, seconds or samples, then hear it back as two sample-accurate clicks, a click loop, or your taps replayed. A tap far from the rest is flagged as it lands and left out of the statistics; measurements can be saved and brought back later. • New: Calculate — a timecode calculator. Add, subtract, scale and divide timecode, frames, seconds, milliseconds and clock time in any mix, with the unit chosen on a sliding switch under each field. A sentence above the result says what was done; the result shows in every form with Copy, and any field takes a paste. • 59.94 and 60 fps in Measure and Calculate. • The app now speaks Japanese, Korean, Simplified Chinese, French and German as well as English.

• New: MTC (MIDI Time Code) in and out, including a virtual MIDI port — "Timecode Tool" — that shows up as a selectable MIDI input in every other app on your device, so your DAW can chase timecode with no cable or MIDI interface. • "Art-Net → LTC" and "LTC → Art-Net" are now one Convert tool: pick any input (LTC, Art-Net, or MTC) and route it to up to two simultaneous outputs. Your existing conversion settings carry over automatically. • Convert now warns you before starting about two setups that used to fail silently: Art-Net in/out sharing a UDP port, and LTC in/out on the built-in speaker and mic. • Generate gained a transport for its running timecode: previous block, back to start of block, play/pause, next block. • Each Convert output now has its own latency trim, so you can line up two outputs that don't arrive at the same time — a DAW chasing MTC and a lighting desk on Art-Net no longer have to share one offset. • Convert warns when MTC is both the input and an output, and stops the conversion if the MIDI input rate becomes impossible for timecode — the signature of a feedback loop through a router or a thru box. • New pictogram-based Tool Home, with Liquid Glass on iOS 26. • Fixed: LTC audio output could run at a slightly wrong frame rate on some sample-rate/fps combinations (most noticeably 29.97 fps at 48 kHz). LTC output is now frame-accurate at every supported rate. • Fixed: the LTC decoder occasionally reported a corrupt frame right when it first locked onto a signal. • Fixed: audio interruptions (phone calls, Siri) did not always resume the timecode stream afterward. They do now. • Fixed: unplugging a USB audio interface mid-session could silently stop audio output in any tool; the app now recovers. • Fixed: "Free-wheel" on source loss only kept LTC running — Art-Net and MTC stopped within a frame, so lighting and a DAW would drop out while video kept going. All outputs now free-wheel together. • Fixed: after a brief signal dropout the sync indicator could stay stuck on "Source Lost" for the rest of the session, and the chosen source-loss behaviour would not run again. • Fixed: Force Resync was unavailable once a conversion was running.