Solitvde 1.4 opens up two more destinations in the modulation matrix. Features: - Filter Q and Mix can now be modulation targets. These were both asked for in an App Store review. Thank you, it was a good idea. Fixes: - On macOS, popover corners now match the panel they sit in. - Slight UI performance improvements.

Solitvde 1.3 is a big feature update. New: - Adds a new Reverse shimmer mode. The shimmer voices read their grains backwards, smearing transients and transforming the texture of the tail. - Exposes a grain control for transforming the period of the shimmer voices. - Exposes two modulation-only parameters in the Motion section - Warp & Ensemble. - The envelope follower gained an onset Delay and tempo-sync. Its Release and Delay can lock to note divisions, so the follower breathes in time with the host. - Side-chain input. Add a second input, so an external signal can drive the modulation in supported hosts. - A new Level fader replaces the separate swell and output gains. Put it before the tank for reverse-style swells, or after it for ducking or tremolo. - A fresh set of factory presets, plus five that show off the new features directly: reverse, long grains, side-chain ducking, synced swells, and warp with ensemble drift. Improvements: - Deeper Warp (±12.5 ms) and Ensemble (12 ms) modulation. - Retuned the envelope Attack and Sensitivity ranges onto log tapers. Fixes: - Fixed a click when Size sat at 0%. The fader now floors at 1%. - The manual button opened an unrelated app on some iOS layouts. It now opens the manual inside the plugin everywhere.

Solitvde 1.2 is a small stability and polish update. Fixes: - Fixed a rare crash when loading Solitvde in some hosts. Certain audio buffer sizes, common when routing through Bluetooth output, could crash it as it started rendering. - Fixed occasional clicks from the Warp modulation at larger audio buffer sizes. Improvements: - Smoother transitions when switching between modulation sources in the source view. - Removed the last memory allocations from the audio render thread, one less source of dropouts under load.

Solitvde 1.1 comes with some new features and fixes a few core issues. Features: - There's now the ability to change filter placement. It can be re-routed from the default, post-tank to either before the tank, or inside the tank's feedback loop. - The in-loop filter has some subtle character, a low-pass darkens the tail, a high-pass thins it, and a band-pass focuses it as it recirculates. - Freeze now holds the tail cleanly at any amount, and the middle of the fader is a long, playable sustain instead of only holding near the top. Fixes: - Dragging or modulating Size, Density, Width, and Damping now applies at sample rate, so fast modulation stays impeccably clean. - Fixed some cases of resonant filters exploding the tank. - Fixed an issue where small freeze and shimmer combinations accumulated too much low-end.