NEW - Save Camera Report, in Help: one file that lets your camera describe itself — model, modes, the values it accepts, what its remote dialect declares. Serial numbers are stripped before anything is written. If you shoot a body that isn't on the verified list below, this file is exactly how it gets there. - The camera can decline a shot: with focus priority set, no AF lock means no frame — and until now the app left that press silent. It now says "Camera declined the shot (no focus)" the moment the camera says so. Nothing was fired, nothing is shown as fired. - When the camera confirms the focus lock on a shot, the post-shot preview now carries a quiet "Focus confirmed" — read straight from the camera's own reply. IMPROVED - Help - Cameras now states a rule every remote session obeys: the camera always saves a JPEG next to your RAW, at your menu's quality — or Large-Fine if the menu says RAW-only. Every remote app gets this, including OM's own; it is how the camera shows you the shot. Your card is not misbehaving. - Diagnostic logging no longer redacts itself in field logs — if you ever send a report, it now carries the data that answers it. THANKS - To Javier of the mu-43 forum, whose E-M5 Mark III field reports shaped 1.0.1 and this release. The About window also carries a credit and a "Thank you". Verified on the OM-1, E-M1 Mark I, E-M1 Mark II, E-M5 Mark II, E-M5 Mark III. On a body not on that list? Help - Save Camera Report, and send us the file.

IMPROVED - The controls got improvements. Olympus and OM System cameras silently substitute a value they can't take (ask for ƒ5.6, get ƒ3.5) and never signal it. The app now treats what it reads back from the camera as the only truth and says so when the camera moved instead of showing the camera's choice as if it were yours. - If the camera reports a value that isn't in its own list, the fader should reflect it proper. - "Signal Lost" no longer appears when you take a photo. The camera pauses live view during every shot — that's normal. While it fetches the post-shot preview you see a "Reading the shot…" instead of a warning. - Help now opens once on first launch. It gained two field-tested tips: raise the camera a few centimetres off the table the Mac sits on (it measurably steadies the WiFi), and expect a warm body after 5–10 minutes of streaming — that's the cost of 30 fps (not applicable to all bodies). FIXED - Fixed a freeze after shooting on older bodies: the post-shot preview could occupy the camera's single command channel while the app tried to "recover" from its own download. Settings changes and focus clicks now take priority over the preview, holding the shutter key fires exactly one shot, and on bodies that serve the preview slowly the app turns it off for the session — Settings has the switch, and I still inspects any shot at full detail. - Fader value labels no longer overlap on smaller windows (overlapping labels could also swallow your click). - Every mode chip explains itself on hover — "iA" is your camera's iAuto. Verified on the OM-1, E-M1 Mark II, E-M5 Mark II — and now the E-M1 Mark I. On a body not on that list? Help - Send Feedback: the model name plus one sentence about what worked is a valuable report.