XTray Pro
Cable tray bends & offsets
$14.99 · Designed for iPad. Not verified for macOS.
XTray Pro is a field tool for cable tray fitters, from the makers of XPipe Pro. Bends, offsets, crossings over obstacles, reducers and tees cut from a straight length of tray — with the marks to scribe before the grinder comes out.
SHEET AND WIRE MESH TRAYS
For sheet trays: a cutting template of the opened-out tray and a table of where to cut from the start of the stock, how wide a wedge to take out and on which side. For wire mesh trays: which cells to cut and how many wires in the bottom and the sides. You enter the mesh cell as your maker builds it — the app does not assume one system.
SEE THE RESULT
The finished-shape preview plays the job through: the wires are cut, then the tray folds to its final shape. Turn it in 3D with a finger, or look at it flat from above or the side. Pinch or tap to zoom.
TOOLS
• Flat bend — a corner on one level, any angle and radius
• Vertical bend — up or down a wall, wedges or saw cuts
• Offset and change of level — two bends, travel and advance
• Crossing an obstacle — over a beam, pipe or another tray, three or four bends
• Width reducer — one side or both
• Tee and cross — the opening in the side, the bottom lap, laterals
• Bill of materials — lengths with waste, splices, bolts, supports, rods, anchors
• Fill and load — percentage fill, kg/m, the smallest standard tray
MEASURE THE WAY YOU DO ON SITE
You enter the route from the points where the centre lines meet, the way it is measured on the job. The app works out how much stock each bend takes and exactly where the cuts fall. It warns when bends run into each other, wedges overlap, or cuts land in the same mesh cell.
NO ADS, NO ACCOUNT
Works offline and collects no data. Polish and English, millimetres or inches, dark and light.
The results are cutting geometry. Check safe loads, support spacing and the design's requirements against the maker's data and the drawings.
Ratings & Reviews
- This app hasn’t received enough ratings or reviews to display an overview.
Wire mesh trays: the preview now cuts wire by wire, in the order you would on site.
Zoomed in, it shows the exact cut lines: every wire to cut, the cross wire you cut against, and the cell number with its distance from the start of the stock.
A new "Next cut" button zooms straight to the next row to cut.
The developer, Jakub Trytek, indicated that the app’s privacy practices may include handling of data as described below. For more information, see the developer’s privacy policy .
Data Not Collected
The developer does not collect any data from this app.
Accessibility
The developer has not yet indicated which accessibility features this app supports. Learn More
Information
- Seller
- Jakub Trytek
- Size
- 945.2 KB
- Category
- Productivity
- Compatibility
Requires iOS 17.0 or later.
- iPhone
Requires iOS 17.0 or later. - iPad
Requires iPadOS 17.0 or later. - Mac
Requires macOS 14.0 or later and a Mac with Apple M1 chip or later. - Apple Vision
Requires visionOS 1.0 or later.
- iPhone
- Languages
- English
- Age Rating
4+
- 4+
- Copyright
- © 2026 Jakub Trytek
