Vaboss 4+

Vaboss Outdoor Control

This VABOSS control is designed for integration into a lamp
powered by a 0~10v or DALI dimming driver, that has been
prior tested by VABOSS as compatible with VABOSS
controls. It is mounted in 40mm IP66 rated Nylon Gland.
VABOSS pole lamp controls part of the X2I-25 integrated
control series. These controls feature simple group function
and VABOSS APP infinite light management control.
They are designed as integrated stand-alone units that
manage lighting in an individual luminaires space.
Presence Detection and Ambient Light management have
been disabled.All Vaboss Controllers are shipped, as standard, in a
“Control Ready” form and should be operational immediately
they are unpacked. They will be set to either control a driver
by either a 0~10v (Default) or DALI interface protocol.
Their electrical interface is a 30cm long, 4-core cable
finished with a Type “A” USB-style male connector.4.1. GENERAL
- The lamp will run to full power on start-up
- The user can connect to any of the control (No 1,2,3,4)
via the app.
- The user can manually change the light level by sliding
the slider as shown in the attachment pictures. The user
can then press disconnect on the top right corner of the
app.
- The lamps will maintain the light level which has been
set by the user until the power is turned off.
- On power up again the lamp/s will go to full power again
- Any dim levels desired by the user can be repeated via the above mentioned process.
- Each lamp must be adjusted individually.This VABOSS control is designed for integration into a lamp
powered by a 0~10v or DALI dimming driver, that has been
prior tested by VABOSS as compatible with VABOSS
controls. It is mounted in 40mm IP66 rated Nylon Gland.
VABOSS pole lamp controls part of the X2I-25 integrated
control series. These controls feature simple group function
and VABOSS APP infinite light management control.
They are designed as integrated stand-alone units that
manage lighting in an individual luminaires space.
Presence Detection and Ambient Light management have
been disabled.All Vaboss Controllers are shipped, as standard, in a
“Control Ready” form and should be operational immediately
they are unpacked. They will be set to either control a driver
by either a 0~10v (Default) or DALI interface protocol.
Their electrical interface is a 30cm long, 4-core cable
finished with a Type “A” USB-style male connector.4.1. GENERAL
- The lamp will run to full power on start-up
- The user can connect to any of the control (No 1,2,3,4)
via the app.
- The user can manually change the light level by sliding
the slider as shown in the attachment pictures. The user
can then press disconnect on the top right corner of the
app.
- The lamps will maintain the light level which has been
set by the user until the power is turned off.
- On power up again the lamp/s will go to full power again
- Any dim levels desired by the user can be repeated via
the above mentioned process.
- Each lamp must be adjusted individually.